Pier and Beam Foundation Repair in Fort Worth & Surrounding Areas
Sagging, bouncy or sloping floors in an older home usually trace back to the crawl space. We repair pier and beam foundations from underneath, with a written estimate and a limited lifetime warranty that transfers when you sell.
How a pier and beam foundation works
A pier and beam house sits up off the ground. The Texas Section of the American Society of Civil Engineers (ASCE) describes it as a structurally supported floor system on piers, posts or footings. Wood beams rest on the piers, joists span between the beams, and the floor sits on the joists. Underneath is an open crawl space.
The outside walls usually rest on a perimeter beam or footing, and the wood sill on top of it ties the house to the foundation.
Pier and beam is common in older homes. Because it's built from many wood parts resting on each other, it can go wrong in more places than a slab. Most of those places can be reached from the crawl space, though.
Signs of pier and beam trouble
- Floors that slope, sag in the middle of a room, or feel bouncy when you walk.
- Doors that stick or drift open, and gaps above door frames.
- Cracks in drywall or plaster, especially above doors and windows.
- Gaps between the baseboard and the floor.
- A musty smell or damp air coming up from below.
- Soft spots in the floor, which can mean rotted wood underneath.
What goes wrong underneath
The ASCE Texas guidelines list the problems engineers find most often in pier and beam foundations:
- Tilting or sinking piers and posts that no longer carry the floor straight down.
- Rotted wood in beams, joists or sills.
- Supports spaced too far apart for the load, so floors sag between them.
- Moisture in the crawl space from poor ventilation or drainage.
- Lost void space, where soil or debris has filled the gap the design needs under parts of the foundation.
Soil plays a part too. The USDA describes Houston Black, the Texas state soil, as clay that shrinks and swells markedly with changes in moisture. Clay like that pushes piers up in wet months and lets them drop in dry ones.
How pier and beam foundations are repaired
The ASCE Texas guidelines describe these repairs:
- Shimming. Hardwood or steel shims go on top of the pier caps to bring the floor framing back to level.
- Framing repairs. Damaged or undersized beams and joists are replaced or reinforced, usually with treated lumber. Rotted sills get the same treatment.
- Added supports. New piers or posts go in where spans are too long, or where old supports have failed.
- Restoring void space under foundation elements where the design calls for it.
- Moisture control in the crawl space: cross ventilation, drainage, and keeping wood off the dirt.
Most homes need a mix of these. Shimming a floor back to level without fixing the rotted joist or the wet crawl space just means doing it again in a few years. So we look at the whole crawl space before we write the estimate.
Why the crawl space check matters
You can't judge a pier and beam house from the living room. The answers are under the floor.
A home inspection for a sale doesn't always get there. Texas home inspection rules say the inspector is not required to enter a crawl space where headroom is less than 18 inches or the access opening is smaller than 24 by 18 inches. If your inspection report says the crawl space was viewed from the opening only, nobody has looked at most of the framing.
When we inspect a pier and beam house, we check the crawl space wherever there's safe room to get in. We look at the piers and shims, the beams, joists and sills, signs of rot, standing water, and how the space is vented. Then we show you photos of what we found.
How a pier and beam repair works with Apex
- Free inspection. We start inside with the floors and doors, then get into the crawl space where there's room. Then we explain what we see.
- Written estimate. You get a written estimate that lists the repair, where the work happens, and the price.
- Engineering when it's called for. When you want it, or when the permit calls for it, our engineering partner takes elevation measurements before and after the repair, so you have documentation of what was done.
- The repair. Our foundation crew does the work, mostly from the crawl space.
- Final walkthrough and warranty. We clean up and walk the job with you. You get your warranty paperwork, plus the after measurements if they were part of the job.
Permits
Each city sets its own rules. In Fort Worth, the residential checklist lists engineered foundation plans and an engineer's structural letter for a foundation repair permit. We'll tell you what your city requires before work starts.
If your home is in a historic district, check with the city before any work that changes the outside of the house, like new skirting or vents.
Helping the repair last
A pier and beam repair lasts longer when the ground around and under the house stays steady:
- gutters and downspouts that carry water away from the house;
- soil that slopes away from the foundation, so rain doesn't run into the crawl space;
- vents that stay open and clear;
- even moisture around the house in dry months.
We'll point out what we see during the inspection. Our guide to watering a foundation in a drought covers the dry months.
Your warranty
Pier and beam repairs come with a limited lifetime warranty that transfers to the next owner if you sell. It covers the repair we did and has conditions. Adding a pool, a major addition or other heavy new load near a repaired area, or work on the foundation or piers by anyone else without our approval can void it. Every condition is written into your contract. See the warranty page for more.
If your floors slope or bounce, call or text 682-558-1382 for a free inspection, or read more about foundation repair and slab foundation repair.
Common questions
How do I know if my house is pier and beam?
Walk around the outside and look for small vent openings or an access door near the base of the walls. Those lead to a crawl space, which means pier and beam. The floors may also feel slightly springy or sound hollow, and there are often a few steps up to the front door.
Why are my pier and beam floors sagging?
Common causes are piers or posts that have tilted or sunk, supports spaced too far apart, shims that have worked loose, and wood beams, joists or sills softened by moisture in the crawl space. Clay soil that shrinks and swells moves the piers too.
What is re-shimming?
Shims are hardwood or steel pieces set on top of the piers to hold the floor framing at the right height. Over time they compress, slip or rot, and the floor drops. Re-shimming resets them to bring the floor back toward level. It's often part of a bigger repair, not a fix by itself.
Can pier and beam repairs be done without tearing up the floors?
Usually, yes. The crawl space gives access to the piers, beams and joists from underneath, so most repairs happen under the house. Access depends on how much room there is down there, which we check during the inspection.
Is the warranty the same as for slab repair?
Yes. Foundation repairs come with a limited lifetime warranty that covers the repair we did and transfers to the next owner if you sell. It has conditions, like adding a pool or a major addition, or work on the foundation by anyone else without our approval. The full terms are in your contract.
Have a leak, storm damage or a project in mind?
Free inspections and written estimates, with photos of what we find.
